Netgear XSM4348CS User Manual - Page 170

M4300 Intelligent Edge Series Fully Managed Stackable Switches Change the Settings for an Existing Stack Member To change the settings for an existing stack member: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select System > Stacking > Stack Configuration. The Stack Configuration page displays. 5. Select the check box next to the stack member to configure. 6. If desired, specify a new unit ID for the stack member in the Change to Switch ID field. The renumbering process causes the unit to reload. 7. Specify the switch type, priority, or management status from the available fields. 8. Click the Apply button. The changes to the stack member are saved. Note: If you configured a new unit number for an existing stack member, you are asked to confirm the change. Click the OK button to continue or click the Cancel button to retain the original settings. 9. To make other changes, do the following: • To remove the selected unit from the stack, click the Delete button. • To update the page with the latest information from the switch, click the Refresh button. Note: If you are adding or removing a dummy unit with PoE for preconfiguration, you must log in again to an actual web session to apply changes and observe relevant PoE web pages. 10. If you made any changes, click the Apply button. Your settings are saved. Manage Stacking 170 User Manual