Netgear XSM4348CS User Manual - Page 58

M4300 Intelligent Edge Series Fully Managed Stackable Switches 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select System > Management > Management Interfaces > IPv6 Management VLAN Configuration. 5. In the Management VLAN ID field, specify the Management VLAN ID of the switch. The management VLAN is used for management of the switch. The VLAN ID can be any value from 1 to 4093. There is no IPv6 management interface configured by default. 6. Select the IPv6 Enable Mode radio button to Enable or Disable the administration mode for the management VLAN IPv6 interface on the switch. 7. Select the radio button to Enable or Disable Address Autoconfigure Mode. If you select Enable, the IPv6 network parameters (IPv6 prefix and prefix length) are autoconfigured for the configured management VLAN interface. The default value for VLAN 1 is Auto Config. Note: The Address Autoconfigure mode option is available only if unicast routing is globally disabled. 8. Select the Address DHCP Mode Enable or Disable radio button. 9. In the IPv6 VLAN Interface Configuration section of the page, select the IPv6 Prefix/Prefix Length option, then specify the IPv6 address to add or remove from the management VLAN interface. When Address Autoconfigure Mode is selected, the appropriate IPv6 prefix and prefix length is shown in this field. 10. Select the EU164 option to True (enabled) the Extended Universal Identifier (EUI) flag for an IPv6 address. The value is False if not specified. 11. Click the Add button. The IPv6 address is added to the management VLAN. 12. Click the Apply button. Configure System Information 58 User Manual