Netgear XSM4348CS User Manual - Page 260

M4300 Intelligent Edge Series Fully Managed Stackable Switches 6. Use Querier Address to specify the snooping querier address to be used as source address in periodic MLD queries. This address is used when no address is configured on the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x. 7. Use MLD Version to specify the MLD protocol version used in periodic MLD queries. 8. Use Query Interval(secs) to specify the time interval in seconds between periodic queries sent by the snooping querier. The query interval must be a value in the range of 1 to 1800. The default value is 60. 9. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the last querier information is removed. The querier expiry Interval must be a value in the range of 60 to 300. The default value is 60. The page displays VLAN IDs enabled for the MLD snooping querier. 10. Click the Apply button. Your settings are saved. Configure MLD Snooping Querier VLAN Settings To configure MLD snooping querier VLAN settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching> Multicast > MLD Snooping > Querier VLAN Configuration. 5. Use VLAN ID to select the VLAN ID on which the MLD snooping querier is administratively enabled and a VLAN exists in the VLAN database. 6. Use Querier Election Participate Mode to enable or disable the MLD snooping querier participation in election mode. Configure Switching Information 260 User Manual