Netgear XSM4348CS User Manual - Page 602

M4300 Intelligent Edge Series Fully Managed Stackable Switches • ACL Based on Source IPv4 L4 Port. To create an ACL based on the source IPv4 Layer 4 port number. • ACL Based on Destination IPv6 L4 Port. To create an ACL based on the destination IPv6 Layer 4 port number. • ACL Based on Source IPv6 L4 Port. To create an ACL based on the source IPv6 Layer 4 port number. Note: For L4 port options, two rules are created: one for TCP and one for UDP. 6. From the Direction menu, select Inbound or Outbound. Traffic rule applies either to inbound traffic only or to outbound traffic only. 7. From the Unit 1 and LAG switch figures onscreen, select the ports and LAGs to which the rule must apply. If a port or LAG is not selected, click the port or LAG to select it. If a port or LAG is selected, click the port or LAG to clear it again. 8. Click the Apply button. Your settings are saved. Configure an ACL Based on Destination MAC Address Note: Binding ACLs to an interface fails if the system has no resources to bind a new ACL. To configure a rule based on destination MAC address: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Security > ACL > ACL Wizard. Manage Switch Security 602 User Manual