Netgear XSM4348CS User Manual - Page 397

M4300 Intelligent Edge Series Fully Managed Stackable Switches 5. In the Area ID field, enter the OSPF area ID. An area ID is a 32-bit integer in dotted-decimal format that uniquely identifies the area to which a router interface connects. 6. In the Import Summary LSAs list, select the Enable or Disable option. If you select Enable, summary LSAs are imported into areas. The default is Enable. 7. In the Default Cost field, enter the metric value to be applied for the default route advertised into the stub area. The valid values range from 1 to 16,777,215. This value is applicable only to stub areas. 8. Click the Add button. The area is configured as a stub area. 9. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information that is displayed. Table 143. Advanced OSPFv3 Stub Area Configuration Field SPF Runs Area Border Router Count Area LSA Count Area LSA Checksum Type of Service Description The number of times that the intra-area route table was calculated using this area's link state database. This is done using Dijkstra's algorithm. The total number of area border routers reachable within this area. This is initially zero, and is calculated in each SPF Pass. The total number of link state advertisements in this area's link state database, excluding AS External LSAs. The 32-bit unsigned sum of the link state advertisements' LSA checksums contained in this area's link state database. This sum excludes external (LSA type 5) link state advertisements. The sum can be used to determine if there was a change in a router's link state database, and to compare the link state database of two routers. This field is the normal ToS associated with the stub metric. Configure the OSPFv3 NSSA Area To configure the OSPFv3 NSSA area: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. Configure OSPF and OSPFv3 397 User Manual