Netgear XSM4348CS User Manual - Page 40

M4300 Intelligent Edge Series Fully Managed Stackable Switches 5. To refresh the page, click the Refresh button. The following table describes the nonconfigurable Device Status information. Table 10. Device Status Field Description Unit ID The unit number in the switch. Firmware Version The release.version.maintenance number of the code currently running on the switch. For example, if the release was 1, the version was 2, and the maintenance number was 4, the format would be 1.2.4. Boot Version The version of the boot code that is in the flash memory to load the firmware into the memory. CPLD Version The version of the software for CPLD. Serial Number The serial number of this switch. Internal AC-1, Internal AC-2, and so on Indicates the status of the appropriate power module in each unit. Status can be any of the following: • Operational. Power module is present and functioning properly. • Powering. Main power is failed or disconnected but RPS provides power to the switch. • Not Present. Power module is not present in the slot. • Not powered. Power module is present but not connected to the power source. • Not powering. Power module is present and connected but the switch uses another power source. • Incompatible. Power module is present but incompatible. • Failed. Power module is present, but power cable is not plugged in or a bad cable is plugged in. System Up Time The time in days, hours, and minutes since the last switch reboot. Configure System Information 40 User Manual