Netgear XSM4348CS User Manual - Page 239

M4300 Intelligent Edge Series Fully Managed Stackable Switches The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching> Multicast > IGMP Snooping > Configuration. 5. Select the Admin Mode Enable or Disable radio button. This selection enables or disables the administrative mode for IGMP snooping for the switch. The default is Disable. 6. Select the Validate IGMP IP header Enable or Disable radio button. This selection enables or disables header validation for all IGMP versions on the switch. If enabled, a packet IGMP IP header validates the Router Alert option, ToS and TTL. The default is Enable. 7. Select the Proxy Querier Mode Enable or Disable radio button. This selection enables or disables the IGMP proxy querier for the switch. If disabled, the IGMP proxy query with source IP address 0.0.0.0 is not sent in response to an IGMP leave packet. The default is Enable. 8. Select the Report Flood Mode Enable or Disable radio button. This selection enables or disables the report flooding mode on the switch. If enabled, IGMP Join/Leave PDUs that the switch receives from a host on a downstream port are forwarded to all other ports in the associated VLAN. The default is Enable. 9. Select the Exclude Mrouter Interface Mode Enable or Disable radio button. This selection specifies the type of information that is forwarded to the upstream multicast router interface. Configure Switching Information 239 User Manual