Netgear XSM4348CS User Manual - Page 257

M4300 Intelligent Edge Series Fully Managed Stackable Switches 9. In the Multicast Router Expiry Time field, specify the value for the multicast router expiration time of MLD Snooping for the specified VLAN ID. The valid range is 0 to 3600. 10. From the Proxy Querier Mode menu, select to enable or disable the proxy querier mode for the specified VLAN ID. If you select Disable, the MLD proxy query with source IP 0::0 is not sent in response to an MLD leave packet. The default value is Enable. 11. From the Exclude Mrouter Interface Mode menu, select to enable or disable the mrouter interface mode. This selection specifies the type of information that is forwarded to the upstream multicast router interface. If enabled, the interface blocks all unknown multicast data through the mrouter port, whether the port is configured dynamically or statically. Only MLD PDUs are allowed to pass through the mrouter port to the upstream router interface. The default is Enable. If disabled, the interface forwards both unknown multicast data and MLD PDUs to the upstream multicast router interface. Note: For information about MLD Plus mode for VLANs, see Configure MLD Snooping for VLANs Automatically with MLD Plus Mode on page 254. 12. Click Add to enable MLD Snooping on the specified VLAN. 13. Click the Apply button. Your settings are saved. Enable or Disable a Multicast Router on an Interface To enable or disable a multicast router on an interface: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching> Multicast > MLD Snooping > Multicast Router Configuration. Configure Switching Information 257 User Manual