Netgear XSM4348CS User Manual - Page 425

M4300 Intelligent Edge Series Fully Managed Stackable Switches 5. Use one of the following methods to select an interface: • In the Go To Interface field, enter the interface in the unit/slot/port format and click on the Go button. • Next to the Interface column, select the check box for the interface that you want to configure. 6. In the Interface Mode field, select the Enable or Disable option to set the administrative mode of the selected DVMRP routing interface. The default is Disable. 7. In the Interface Metric field, enter the DVMRP metric for the selected interface. This value is sent in DVMRP messages as the cost to reach this network. Valid values are 1 to 31. The default value is 1. 8. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information that is displayed. Table 156. DVMRP Interface Configuration Field Protocol State Local Address Generation ID Received Bad Packets Received Bad Routes Sent Routes Description The operational state of the DVMRP protocol on the selected interface, either Operational or Non-Operational. The IP address used as a source address in packets sent from the selected interface. The DVMRP generation ID used by the router for the selected interface. This value is reset every time an interface is started and is placed in prune messages. A change in generation ID informs the neighbor routers to discard any previous information about this router. The number of invalid packets received on the selected interface. The number of invalid routes received on the selected interface. The number of routes sent on the selected interface. Configure Multicast Routing 425 User Manual