Netgear XSM4348CS User Manual - Page 63

M4300 Intelligent Edge Series Fully Managed Stackable Switches The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. 4. Click the Login button. The System Information page displays. 5. Select System > Management > Management Interfaces > IPv6 Management Interface Configuration. 6. Use the Interface list to select the interface for which IPv6 parameters or management interface can be changed. 7. When you select the Set Management Interface option, it means that the management interface must be configured based on the interface selected. By default, this option is not selected. 8. Select the radio button to enable or disable the Routing Mode on the management interface. 9. Select the radio button to enable or disable the IPv6 Mode on the management interface. 10. Select the radio button to enable or disable the DHCPv6 Client Mode on the management interface. 11. Select the radio button to enable or disable the Address Autoconfigure Mode on the management interface. Note: The Address AutoConfigure Mode option is available only if Unicast Routing is globally disabled. 12. Click the Apply button. Your settings are saved. In the IPv6 Default Route Configuration section of the page, the nonconfigurable IPv6 Default Route that is displayed is the default route for the IPv6 management interface. Configure System Information 63 User Manual