Panasonic AW-UE100 Operating Instructions - Page 16
Wireless remote control (optional accessory), If the unit is installed near fluorescent lights, plasma
View all Panasonic AW-UE100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Wireless remote control (optional accessory) This unit can be operated by remote control using a wireless remote control (model number: AW‑RM50G) purchased separately. Check out the following points before using the wireless remote control. zzPoint the wireless remote control at the unit's wireless remote control signal light-sensing area (front panel or back panel), and operate it within a range of 10 meters (32.8 ft) from these areas. zzRefer to on the right. zzThe signal sensing distance is reduced if the angle at which the wireless remote control signals are sensed is increased. The light-sensing sensitivity is reduced to about one-half when the wireless remote control is pointed at an angle of 40 degrees from each position in front of a wireless remote control signal light-sensing area (front panel or back panel). If the remote control is operated from the behind the unit, it may be either difficult or impossible to perform the desired operations. zzWhen the unit is to be operated by the wireless remote control from the rear, remove the cable cover. zzIf the unit is installed near fluorescent lights, plasma monitors or other such products or if the unit is exposed to sunlight, the effects of the light may make it impossible for the unit to be operated using the wireless remote control. Be sure to follow the steps below for installation and use. • Take stesps to ensure that the wireless remote control signal lightsensing area will not be exposed to the light from fluorescent lights, plasma monitors or other such products or from the sun. • Install the unit away from fluorescent lights, plasma monitors and other such products. zzFor about 10 minutes even after the batteries have been removed from the wireless remote control, the selection of the operation to be performed (the , , or button which was pressed last) will remain stored in the memory. When a longer period of time elapses, however, the selection is reset to the status established when the button was pressed. • The arrows in the figure below show the light-sensing directions in which the wireless remote control signals travel. Wireless remote control signal light-sensing area (back panel, 1 place) Wireless remote control signal lightsensing area (front panel, 2 places) • Top view Approx. 45° Approx. 45° • Rear panel view Wireless remote control signal light-sensing area 16