Panasonic AW-UE100 Operating Instructions - Page 30

Setting the remote control IDs The wireless remote control (optional accessory) is capable of operating up to four units. IDs are used to set which units are selected when the , , and buttons on the wireless remote control have been pressed. • When operating a multiple number of these units using wireless remote controls, set a different remote control ID for each control. • When using one unit, set the remote control ID to "CAM1" unless the setting needs to be changed. „„Setting procedure Operate the IR ID switches on the unit's rear panel, and select "CAM1", "CAM2", "CAM3" or "CAM4" as the remote control ID. (→ page 19) The IR ID switch settings "CAM1" to "CAM4" correspond to the to buttons on the wireless remote control. (The factory setting is "CAM1".) RS-422 G/L IN AUDIO IN 3G SDI OUT 12G SDI OUT IR ID DC IN 12 V LAN LINK ACT SERVICE IR ID switches „„Setting the installation method ("Desktop" or "Hanging") from the OSD menu Set "Desktop" or "Hanging" in [Install Position] on the [Pan/Tilt 1/2] screen from the OSD menu of this unit. Pan/Tilt 1/2 Install Position Desktop Smart Picture Flip Off Flip Detect Angle 90deg P/T Speed Mode Normal(60deg/s) P/T Acceleration Setting Speed With Zoom Position On Focus Adjust With PTZ. Off Privacy Mode Off Return Install Position [Desktop, Hanging] [Desktop] or [Hanging] is selected here as the method used to install the unit. Desktop Stand-alone installation Hanging Suspended installation • When [Hanging] has been selected, the top, bottom, left and right of the images will be reversed, and up/down/left/right control for panning and tilting will also be reversed. to buttons 30