Panasonic AW-UE100 Operating Instructions - Page 64

Camera menu items (continued) „„Tracking data output When [Serial] or [IP] of [Tracking Data Output] on the [System 2/2] screen is set to [On], outputs the tracking data for Pan/Tilt/Zoom or other information to link with a virtual studio system or elsewhere via serial (RS-422) or IP output. zzSerial (RS-422) output • When [Serial] of [Tracking Data Output] on the [System 2/2] screen is set to [On], the tracking data for Pan/Tilt/Zoom or other information is synchronized with the Genlock signal and output via the serial output (RS-422). • The tracking data is output in stream mode in a format conforming to the free-d protocol. The message type is Type D1 (camera position/ orientation data) only. Advanced stored data This unit stores and outputs the following data according to the packet structure specified in Type D1 of the free-d protocol. Camera ID Always stores FFh. Camera Pan Angle Stores the Pan angle of the unit (-175° to +175°) with the format provided by the free-d protocol. Camera Tilt Angle Stores the Tilt angle of the unit (-30° to +210°) with the format provided by the free-d protocol. • The range of the angle is limited to between -90° and +90° in the free-d protocol. However, this unit can store greater angles than +90° (up to +210°). Camera Roll Angle Stores the rotation angle (0° or 180°) corresponding to the flip state (turned upside down or left-right reversed) of the unit with the format provided by the free-d protocol. Stores an angle of 180° in the flipped state (turned upside down or left-right reversed) (exceeding the angle specified when [Smart Picture Flip] is [On]), and stores 0° other than in this condition. Camera X-Position Always stores 000000h. Camera Y-Position Always stores 000000h. Camera Height (Z-Position) Always stores 000000h. Camera Zoom Stores the magnification of optical zoom of this unit between 000555h (WIDE) and 000FFFh (TELE). • The magnification of digital zoom is not stored. Camera Focus Stores the value of focus position of this unit between 000555h (NEAR) and 000FFFh (FAR). Spare / User Defined (16bit) Stores the value of iris position of this unit between 0555h (CLOSE) and 0FFFh (OPEN). Checksum Stores the checksum value provided by the free-d protocol. • The serial connection of the remote controller (AW-RP150 or AW‑RP60, etc.) cannot be made if [Serial] is already [On]. • In the following cases, the tracking data output may be delayed or the value may not be updated. - While viewing the OSD menu - While recalling the preset value during an ongoing preset recall - When executing AWB/ABB - When a red or a green tally signal input has been changed between Off and On - When deleting a preset memory - When an output image is flipped (turned upside down or left-right reversed) - After switching [Scene] - After switching [Iris Mode] - After switching [Super Gain] - After switching [White Balance Mode] - After switching each item of [Color TEMP. Setting] - After switching [Gamma Mode] - After switching [Matrix Type] - After switching [Focus Mode] - After switching [Zoom Mode] - After switching [Max Digital Zoom] - After switching [Digital Extender] - After switching [Fan] - After switching [OSD Mix/Crop Marker] - After switching [Tally] - After moving the crop frame of [UHD Crop] - After switching [Install Position] - After switching [Preset Speed Unit] - When executing [Initialize] of [Maintenance] 64