Sony PDWHD1500 User Manual (PDW-HD1500 / PDW-F1600 Operation Manual for Firmwa - Page 29
SDSDI OUTPUT 1, 2 SUPER SDI signal outputs, COMPOSITE OUTPUT 1, 2 SUPER analog
View all Sony PDWHD1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 2 Names and Functions of Parts See page 126 for more information about the setup menu item 028 HD CHARACTER. To treat the input and output signals of these connectors as non-audio signals, set the maintenance menu item M37: AUDIO CONFIG >M372: NON-AUDIO INPUT (recording) (see page 148) and setup menu item 823 NONAUDIO FLAG PB (playback). h COMPOSITE OUTPUT 1, 2 (SUPER) (analog composite video output 1, 2 (superimpose)) connectors (BNC type) Output analog composite video signals. You can superimpose timecodes, menu settings, or error messages on the output of the 2 (SUPER) connector when CHAR SEL on the HOME page of the function menu is set to ON. See "Basic Operations of the Function Menu" on page 48 for more information about the CHAR SEL setting. i REF.VIDEO INPUT (reference video signal input) connectors (BNC type) The two connectors form a loop-through connection; when a reference video signal is input to the left connector, the same signal is input from the right connector ( ) to a connected device. When no connection is made to the right connector, the left connector is automatically terminated with an impedance of 75 ohms. j (network) connector (RJ-45 type) This is a 10BASE-T/100BASE-TX/1000BASE-T connector for network connection. CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. Follow the instructions for this port. ATTENTION Par mesure de sécurité, ne raccordez pas le connecteur pour le câblage de périphériques pouvant avoir une tension excessive à ce port. Suivez les instructions pour ce port. ACHTUNG Aus Sicherheitsgründen nicht mit einem PeripheriegerätAnschluss verbinden, der zu starke Spannung für diese Buchse haben könnte. Folgen Sie den Anweisungen für diese Buchse. k MAINTENANCE connectors These are the USB connectors for maintenance. Connect a Windows USB keyboard or mouse (see page 83), or a USB flash drive to access planning metadata stored on the drive (see page 94). l SDSDI OUTPUT 1, 2 (SUPER) (SDI signal outputs 1, 2 (superimpose)) connectors (BNC type) These output SDSDI format video/audio signals. When the unit is shipped from the factory, audio signal output is eight channels with no switching, and RP188 timecode output is set to on. You can change these settings with setup menu item 828 SDI AUDIO OUTPUT SELECT and setup menu item 920 SD-SDI H-ANC CONTROL. The output from the 2 (SUPER) connector can have timecode, menu settings, alarm messages, and other text information superimposed. To turn superimposition off, set CHAR SEL on the HOME page of the function menu to "OFF". See "Items in the extended menu" (page 131) for more information. See "Basic Operations of the Function Menu" (page 48) for more information. 1 Power supply section 1 POWER switch 2 - AC IN connector POWER AC IN a POWER (main power) switch Press the : side to power on the unit. Press the a side to power off. When using the unit, normally leave the POWER switch in the : (on) position, and use the on/standby button on the front panel to switch the unit between the operating state and standby state. Note Before turning the main power off, always check to be sure that the unit is in the standby state, and then press the main power switch to the a side. b -AC IN connector Connect to an AC power supply with the power cord (not supplied). 29 Rear Panel