Sony PDWHD1500 User Manual (PDW-HD1500 / PDW-F1600 Operation Manual for Firmwa - Page 66

Chapter 4 Recording and Playback Playback in shuttle mode In shuttle mode, you can control the speed of playback by the angular position of the shuttle dial. The range of playback speed is ±20 times normal speed or maximum speed (as selected by an extended menu setting). 1) 1) Maximum speed is about ±50 times normal speed. However, the maximum speed may vary depending on the state of the clip and the playback position on the disc. To carry out playback in shuttle mode, proceed as follows. EJECT ACCESS CH-1 CH-3 PUSH SET(S.SEL) MARK1 IN OUT ALL CH CH-2 CH-4 CHAPTER NET LOCAL REMOTE VARIABLE KEY INHI REC PRE- ON SET OFF PB EXPAND PAGE HOME PHONES LEVEL DISPLAY PREV PLAY NEXT STOP REC THUMBNAIL MENU RESET SHTL/JOG MARK2 VAR/JOG RETURN SHIFT SUB CLIP TOP F REV F FWD END STANDBY REC INHI DISC MENU EJECT ACCESS CH-1 CH-3 PUSH SET(S.SEL) MARK1 IN OUT ALL CH CH-2 CH-4 CHAPTER NET LOCAL REMOTE VARIABLE KEY INHI REC PRE- ON SET OFF PB EXPAND PAGE HOME PHONES LEVEL DISPLAY PREV PLAY NEXT STOP REC THUMBNAIL MENU RESET SHTL/JOG MARK2 VAR/JOG RETURN SHIFT TOP F REV SUB CLIP F FWD END STANDBY REC INHI DISC MENU 3 1 2,3 1 Press the SHTL/JOG button, turning it on. 2 Turn the shuttle dial to the desired angle corresponding to the desired playback speed. Playback in shuttle mode starts. 3 To stop playback in shuttle mode, return the shuttle dial to the center position, or press the STOP button. When setup menu item 101 SELECTION FOR SEARCH DIAL ENABLE is set to "dial" (factory default setting), you can start shuttle playback by simply rotating the shuttle dial, even when the SHTL/ JOG button is not lit. To alternate between normal-speed playback and shuttle mode playback Set the shuttle dial to the position corresponding to the desired shuttle playback speed, then switch between normal-speed playback and shuttle playback by pressing the PLAY and SHTL/JOG buttons alternately. Playback in variable-speed mode In variable-speed mode, you can control the speed of playback in the range of -2 to +2 times normal speed. (You can use setup menu item 119 VARIABLE SPEED LIMIT IN KEY to specify the speed range of variable playback.) To carry out playback in variable-speed mode, proceed as follows. 3 2,3 1 1 Press the VAR/JOG button, turning it on. 2 Turn the shuttle dial to the desired angle corresponding to the desired playback speed. Playback in variable-speed mode starts. 3 To stop playback in variable-speed mode, return the shuttle dial to the center position, or press the STOP button. To alternate between normal-speed playback and variable-speed mode playback Set the shuttle dial to the position corresponding to the desired variable playback speed, then switch between normal-speed playback and variable-speed mode playback by pressing the PLAY and VAR/JOG buttons alternately. To repeat playback in variable mode Set setup menu item 142 REPEAT MODE to "play & VAR fwd" or "force". This allows you to perform repeat playback, limited to variable playback in the forward direction in the range 0 to ±2 times normal speed. To perform manual frame sync playback During playback, you can adjust the playback output phase in units of one frame. To do so, hold down the PLAY button and turn the PUSH SET(S.SEL) knob in either direction. To speed up the phase: Turn clockwise. To delay the phase: Turn counterclockwise. Playback operations using thumbnails Playback operations that you can perform with thumbnails include searching for clips, displaying clip information, playing clip lists created with the scene selection function, and locking and deleting clip. This allows you to check the actual video as you work. 66 Playback