ZyXEL NBG4615 User Guide - Page 168
Advanced
View all ZyXEL NBG4615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Chapter 19 DHCP Server Figure 107 Network > DHCP Server > General The following table describes the labels in this screen. Table 67 Network > DHCP Server > General LABEL Enable DHCP Server DESCRIPTION Select the checkbox to enable DHCP for LAN. IP Pool Starting Address Pool Size Apply Cancel DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients (computers) to obtain TCP/IP configuration at startup from a server. Leave the Enable DHCP Server check box selected unless your ISP instructs you to do otherwise. Clear it to disable the NBG4615 acting as a DHCP server. When configured as a server, the NBG4615 provides TCP/IP configuration for the clients. If not, DHCP service is disabled and you must have another DHCP server on your LAN, or else the computers must be manually configured. When set as a server, fill in the following four fields. This field specifies the first of the contiguous addresses in the IP address pool for LAN. This field specifies the size, or count of the IP address pool for LAN. Click Apply to save your changes back to the NBG4615. Click Cancel to begin configuring this screen afresh. 19.3 Advanced This screen allows you to assign IP addresses on the LAN to specific individual computers based on their MAC addresses. You can also use this screen to configure the DNS server information that the NBG4615 sends to the DHCP clients. To change your NBG4615's static DHCP settings, click Network > DHCP Server > Advanced. The following screen displays. 168 NBG4615 User's Guide