ZyXEL NBG4615 User Guide - Page 17
Wall Mounting - router
View all ZyXEL NBG4615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Chapter 1 Introduction Table 1 Front panel LEDs and WPS button (continued) LED WAN WLAN/WPS COLOR Green Amber Off Green STATUS On Blinking Blinking On Blinking DESCRIPTION The NBG4615's WAN connection is ready. The NBG4615 is sending/receiving data through the WAN with a 10/100Mbps transmission rate. The NBG4615 is sending/receiving data through the WAN with a 1000Mbps transmission rate. The WAN connection is not ready, or has failed. The NBG4615 is ready, but is not sending/receiving data through the wireless LAN. The NBG4615 is sending/receiving data through the wireless LAN. USB 1-2 Off Green Off On Blinking The NBG4615 is negotiating a WPS connection with a wireless client. The wireless LAN is not ready or has failed. The NBG4615 has a USB device installed. The NBG4615 is transmitting and/or receiving data from routers through an installed USB device. There is no USB device connected to the NBG4615. 1.6 Wall Mounting You may need screw anchors if mounting on a concrete or brick wall. Table 2 Wall Mounting Information Distance between holes M4 Screws Screw anchors (optional) 12 cm Two Two 1 Select a position free of obstructions on a wall strong enough to hold the weight of the device. 2 Mark two holes on the wall at the appropriate distance apart for the screws. Be careful to avoid damaging pipes or cables located inside the wall when drilling holes for the screws. 3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave a small gap of about 0.5 cm. If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all the way in - leave a gap of about 0.5 cm. 4 Make sure the screws are fastened well enough to hold the weight of the NBG4615 with the connection cables. 5 Align the holes on the back of the NBG4615 with the screws on the wall. Hang the NBG4615 on the screws. NBG4615 User's Guide 17