Brother International DreamWeaver„ VQ3000 Users Manual - English - Page 101
Gathering, Flat Fell Seam
View all Brother International DreamWeaver„ VQ3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
e Iron the dart to one side so that it is flat. SEWING THE STITCHES d Sew two rows the seam line, of straight stitches parallel then trim excess thread to leaving 50 mm (approx. 1-15/16 inches). S 2 Utility Stitches Gathering Use on waists of skirts, sleeves of shirts, etc. a Select a straight foot "J". stitch and attach presser a Seam line b 10 mm to 15 mm (approx. 3/8 inch to 9/16 inch) c About 50 mm (approx. 1-15/16 inches) e Pull the bobbin threads to obtain the desired amount of gather, then tie the threads. f Smooth the gathers by ironing them. b Set the stitch length to 4.0 mm (approx. 3/16 inch) and the thread tension to approximately 2.0 (weaker tension). * If you press after pressing and then , the stitch length will be set automatically to 4.0 mm (approx. 3/16 inch) and the thread tension will be automatically set to 2.0. c Pull the bobbin and upper threads out by 50 mm (approx. 1-15/16 inches) ("Pulling Up the Bobbin Thread" of "Basic operations"). g Sew on basting the seam stitch. line and remove the Flat Fell Seam Use for reinforcing seams and finishing edges neatly. a Select and attach presser foot "J". a Upper thread b Bobbin thread c About 50 mm (approx. 1-15/16 inches) b Sew the finish line, then cut allowance from the side on half of which the the seam flat fell seam will lie. * When the automatic thread cutting and automatic reinforcement stitching are preset, reinforcement stitches will be sewn automatically at the beginning of sewing. Press the "Reverse Stitch" button to sew a Sewing S-29