Brother International DreamWeaver„ VQ3000 Users Manual - English - Page 214

ERROR MESSAGES Marks Error Messages OK to delete the setting? Preventive maintenance is recommended. Cause/Solution This message appears when or is pressed to delete the settings for a utility stitch. To delete the selected settings, press . This message is displayed when the machine needs to be maintained. (see page A-15) Raise the buttonhole lever. Sensor module error. This message is displayed when the buttonhole lever is down, a stitch other than a buttonhole is selected, and the "Start/Stop" button or the "Reverse Stitch" button is pushed. This message appears when something is wrong with the sensor unit of the machine. Consult your authorized dealer. Set the clock. This message appears when the time/date is not set. Set time/date. (see page B-20) The bobbin thread is almost empty. This message is displayed when the bobbin thread is running out. The bobbin winder safety device has activated. Is the thread This message is displayed when the bobbin is being wound, tangled? and the motor locks because the thread is tangled, etc. The ending point cannot be selected for this stitch. The needle position cannot be changed for this stitch. The needle will move. Keep your hands etc. away from the needle area. The pockets are full. Delete a pattern. This message appears when the function to specify the sewing end point cannot be used with the current stitch. Select other stitch. (see page B-69) This message appears when the function to specify the needle drop position cannot be used with the current stitch. Select other stitch. (see page B-69) This message appears when you touch the point closer than 2 cm from the needle drop point with the sensor pen in the sensor function. (see page B-61) This message is displayed when the memory is full and a pattern must be deleted. The safety device has been activated.Is the thread tangled? Is This message is displayed when the motor locks due to the needle bent? tangled thread or for other reasons related to thread delivery. The shutoff support mode has been activated. Turn off the machine. The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller. The upper thread may not be threaded correctly. Thread the upper thread from the beginning. This message appears when the machine is in the shutoff support mode. Turn off the machine once to start the machine again. (see page B-28) This message is displayed when the "Start/Stop" button is pushed to sew Utility stitches or Character/Decorative stitches while the foot controller is connected. This message is displayed when it seems that the upper thread has not been threaded correctly. The USB media was changed. Do not change the USB media This message is displayed when you attempt to select a while it is being read. pattern after the USB media in which the pattern is saved has been changed. There is no needle plate cover. Attach a needle plate cover. This message is displayed when the needle plate cover is not attached. This file cannot be used. This message appears if the file format is incompatible with this machine. Check the list of compatible file formats. (see page S-94) This file exceeds the data capacity and cannot be used. Use a This message is displayed when the file size exceeds the data suitable size file. capacity of the machine. Confirm the file size and format. (see page S-95) This function cannot be used while in the sensor mode. This message appears when the selected function is not available with the sensor function. (see page B-59) This key cannot be used at this time. This message is displayed when you press in the screen other than the Utility Stitch, or press in the screen other than the Utility Stitch or Character/Decorative Stitch. A-30