Brother International DreamWeaver„ VQ3000 Users Manual - English - Page 194

CREATING BOBBIN WORK h Use the presser presser foot. foot lever to raise the i With the wrong side facing up, fabric under the presser foot. place the Note • If the bobbin thread does not come up, hold the upper thread as shown below to pull up the bobbin thread. a Wrong side of fabric j Turn the handwheel toward you (counterclockwise) to feed the needle into the fabric or punched hole. Position the upper thread over the presser foot and lightly hold, and then lower the presser foot lever. a Upper thread l Raise the presser foot lever, and then use tweezers to pull up the bobbin thread and bring the end of the thread to the top of the fabric. Note • Pull the thread while holding down the fabric so it does not move out of place. m Align the upper thread and bobbin thread, and then pass them under the presser foot toward the rear of the machine. a Punched hole b Upper thread over the presser foot k Pulling the upper thread gently, turn the handwheel toward you (counterclockwise) until the mark on the handwheel aligns with the center top of machine. n While gently holding threads at the rear of the machine, turn the handwheel to feed the needle into the fabric or punched hole again, and then lower the presser foot lever. o Press at lower right of LCD screen. → All keys and operation buttons are unlocked, and the previous screen is displayed. p Select a low speed, gently hold the threads behind the presser foot and start sewing. Threads can be released after several stitches have been made. → A loop of the bobbin thread comes out through the hole in the fabric. A-10