Brother International DreamWeaver„ VQ3000 Users Manual - English - Page 84
Setting the Thread Tension
View all Brother International DreamWeaver„ VQ3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
STITCH SETTINGS Setting the Thread Tension You may need to change the thread tension, depending on the fabric and thread being used. Follow the steps below to make any necessary changes. ■ Proper Thread Tension The upper thread and the bobbin thread should cross near the center of the fabric. Only the upper thread should be visible from the right side of the fabric, and only the bobbin thread should be visible from the wrong side of the fabric. Press , to loosen the upper thread. Memo • When you finish sewing, remove the bobbin cover and then make sure that the thread is shown as below. If the thread is not shown as below, the thread is not inserted through the tension-adjusting spring of the bobbin case correctly. Reinsert the thread correctly. For details, refer to "Setting the Bobbin" of "Basic operations". a Wrong side b Surface c Upper thread d Bobbin thread ■ Upper Thread is Too Tight If the bobbin thread is visible on the right side of the fabric, the upper thread is too tight. Note • If the bobbin thread was incorrectly threaded, the upper thread may appear to be too tight. In this case, refer to "Setting the Bobbin" of "Basic operations" and rethread the bobbin thread. ■ Upper Thread is Too Loose If the upper thread is visible from the wrong side of the fabric, the upper thread is too loose. Note • If the upper thread was incorrectly threaded, the upper thread may appear to be too loose. In this case, refer to "Upper Threading" of "Basic operations" and rethread the upper thread. a Upper thread b Bobbin thread c Wrong side d Locks appear on wrong side of fabric Press , to tighten the upper thread. a Bobbin thread b Upper thread c Surface d Locks appear on surface of fabric Memo • Press after pressing original setting. to return to the S-12