Brother International DreamWeaver„ VQ3000 Users Manual - English - Page 191
When tension is not applied to the, bobbin thread
View all Brother International DreamWeaver„ VQ3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
PREPARING FOR BOBBIN WORK ■ When tension is not applied to the bobbin thread m Gently pull the upper thread to bring the bobbin thread up through the needle plate. If the bobbin thread in the trial stitching is too tight A and adjusting the bobbin case tension does not help, do not pass the thread through the tension spring. 1 Hold the bobbin with your left hand so the thread unwinds from the right side and hold the end of the thread with your right hand. How to Create Bobbin Work → A loop of the bobbin thread comes out through the hole in the needle plate. n Insert tweezers through bobbin thread loop and pull bobbin thread above the needle plate. o Align the upper thread and bobbin thread, and then pull out about 10 cm (approx. 4 inches) of the threads and pass them under the presser foot toward the rear of the machine. k Pull out about 8 bobbin thread. cm (approx. 3 inches) of l Lightly hold the end of the upper thread while turning the handwheel toward you (counterclockwise) until the mark on the handwheel aligns with the center top of machine. Appendix A-7