Cisco 7965G Administration Guide - Page 58

Installing the Cisco Unified IP Phone Chapter 3 Setting Up the Cisco Unified IP Phone Using External Devices with Your Cisco Unified IP Phone The following information applies when you use external devices with the Cisco Unified IP Phone: Cisco recommends the use of good quality external devices that are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of these devices and their proximity to other devices such as mobile phones or two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or more of the following actions: • Move the external device away from the source of the RF or AF signals. • Route the external device cables away from the source of the RF or AF signals. • Use shielded cables for the external device, or use cables with a better shield and connector. • Shorten the length of the external device cable. • Apply ferrites or other such devices on the cables for the external device. Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external devices, cables, and connectors. The system will perform adequately when suitable devices are attached using good quality cables and connectors. Caution In European Union countries, use only external headsets that are fully compliant with the EMC Directive [89/336/EC]. Installing the Cisco Unified IP Phone You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See Figure 3-1 for a graphical representation of the connections. Note Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before using external devices, read the "Using External Devices with Your Cisco Unified IP Phone" section on page 3-6 for safety and performance information. To install a Cisco Unified IP Phone, perform the following steps: Table 3-1 Installing the Cisco Unified IP Phone 7965G and 7945G Configuration Step and Notes Step 1 Connect the handset to the Handset port. - Step 2 Connect a headset to the Headset port. Optional. You can add a headset later if you do not connect one now. Step 3 Connect the power supply to the Cisco DC Adapter port. Optional. Reference - See the "Headset" section on page 3-4 for supported headsets. See the "Providing Power to the Phone" section on page 2-3. Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1 3-6 OL-14641-01