Cisco 7965G Administration Guide - Page 63
Before You Begin, Procedure, Installing, the Wall Mount Kit for the Cisco Unified IP Phonee
UPC - 882658140464
View all Cisco 7965G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Chapter 3 Setting Up the Cisco Unified IP Phone Adjusting the Placement of the Cisco Unified IP Phone See Figure 3-3 for a graphical representation of the phone parts. Before You Begin To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook from the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip on which the handset catches when the phone is vertical. For an illustrated procedure, refer to Installing the Wall Mount Kit for the Cisco Unified IP Phonee at: http://www.cisco.com/en/US/products/hw/phones/ps379/prod_installation_guides_list.html To mount the phone on the wall using the standard footstand, follow these steps: Caution Use care not to damage wires or pipes located inside the wall when securing screws to wall studs. Procedure Step 1 Step 2 Step 3 Step 4 Push in the footstand adjustment button. Adjust the footstand so it is flat against the back of the phone. Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand. The keyholes fit standard phone jack mounts. Hang the phone on the wall. Figure 3-3 Parts Used in Wall Mounting the Cisco Unified IP Phone 1 Footstand adjustment button-Raises and lowers adjustment plate 2 Wall mounting screw holes 3 Adjustment plate-Raises and lowers phone vertically OL-14641-01 Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1 3-11