Compaq DL580R01 Service Guide - Page 176

Index A AC power cable assembly part number 1-6 removing 2-47 removing from chassis, illustrated 2-49 removing ground wire screw 2-48 replacing 2-49 unplugging from power backplane board 2-48 AC power supply See power supply accelerator board not detected 3-34 accelerator error log 3-34 accelerator parity read errors 3-34 write errors 3-34 accelerator status cache was automatically configured 3-34 data in the cache was lost due to some reason other than the battery being discharged 3-34 dirty data detected has reached limit 3-34 dirty data detected, unable to write 3-35 excessive ECC errors detected 3-35 obsolete data detected 3-35 discarded 3-35 flushed 3-35 permanently disabled 3-35 possible data loss in cache 3-35 temporarily disabled 3-35 unrecognized status 3-36 valid data found at reset 3-36 warranty alert 3-36 access door (PCI Hot Plug) opening 2-37 access panel See top access panel ACU accessing 3-5, 3-6 accessing from System Configuration 3-6 executing 3-6 adapter/NVRAM ID mismatch 3-36 ADU accessing 3-5 description 3-3, 3-33 executing 3-6 starting 3-33 ADU error messages 3-34, 3-52 accelerator board 3-34 accelerator error 3-52 adapter error 3-36 array accelerator 3-34, 3-35, 3-36 board error 3-36 cabling errors 3-48 controller 3-37 controller drive detections 3-50 drive problems 3-38, 3-50 hard drives 3-37, 3-38, 3-43, 3-44 NVRAM configuration 3-41 soft firmware upgrade required 3-44 warnings 3-51 array accelerator ADU error messages 3-35 capacity 3-42 array accelerator battery pack X below reference voltage (recharging) 3-36 not fully charged 3-36 Array Configuration Utility See ACU