Compaq DL580R01 Service Guide - Page 82
Run the System Configuration, failed Set Block
UPC - 720591221416
View all Compaq DL580R01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Diagnostics and Troubleshooting 3-13 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1724-Slot x Drive None Array - Physical Drive Position Change(s) Detected - Logical drive configuration has automatically been updated 1726-Slot x Drive None Array - Array Accelerator Memory Size Change Detected 1727-Slot x Drive None Array - New Logical Drive(s) Attachment Detected. If more than 32 logical drives, this message will be followed by: Auto-configuration failed: Too many logical drives. 1730-Fixed Disk 0 None does not support DMA Mode. 1731-Fixed Disk 1 None does not support DMA Mode. 1740-Fixed Disk 0 None failed Set Block Mode command 1741-Fixed Disk 1 None failed Set Block Mode command 1750-Fixed Disk 0 None failed Identify command 1751-Fixed Disk 1 None failed Identify command 1760-Fixed Disk 0 None does not support Block Mode Probable Source of Problem Logical drive configuration has been updated automatically following physical drive position changes. Recommended Action Press F1 to resume. Indicates array accelerator configuration has been updated automatically due to replacement of array accelerator (or controller) with one having different memory size. Controller has detected an additional array of drives that were attached when the power was off. The logical drive configuration information has been updated to add the new logical drives. The maximum number of logical drives supported is 32. Additional logical drives will not be added to the configuration. Hard drive error Press F1 to resume. Press F1 to resume. Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. Hard drive error Run the System Configuration Utility and correct. continued