Compaq DL580R01 Service Guide - Page 43
Processor Terminator Module, to release the processor terminator module from
UPC - 720591221416
View all Compaq DL580R01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Removal and Replacement Procedures 2-27 Processor Terminator Module IMPORTANT: If a processor is removed, the processor terminator module must be reinstalled before powering up the server. Failure to have either a processor or processor terminator module installed results in an interlock fault condition that prevents the server from powering up. To remove a processor terminator module: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the top access panel. See "Top Access Panel" earlier in this chapter. 3. Loosen the retention screw . 4. Pull up the two ejector levers to release the processor terminator module from the connector slot. 5. Lift the processor terminator module out of the slot. 2 2 1 3 Figure 2-20. Removing a processor terminator module Reverse steps 1 through 5 to replace a processor terminator module.