Compaq DL580R01 Service Guide - Page 60
Power Backplane Board, Remove the four T-15 screws
UPC - 720591221416
View all Compaq DL580R01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
2-44 Compaq ProLiant DL580 Server Maintenance and Service Guide Power Backplane Board To remove the power backplane board: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Pull all power supplies partially out of the unit. See "Hot-Plug Power Supply" earlier in this chapter. 3. Remove the PCI guide bracket. See "PCI Guide Bracket" earlier in this chapter. 4. Remove the center wall. See "Center Wall" earlier in this chapter. 5. Disconnect all remaining cables from the power backplane board assembly. 6. Remove the four T-15 screws that secure the backplane board to the backplane board subpan, then lift the backplane board from the subpan. 1 1 1 2 6 Figure 2-35. Removing the power backplane board from the subpan Reverse steps 1 through 6 to replace the power backplane board assembly.