HP 2605dn HP Color LaserJet 2605/2605dn/2605dtn - User Guide - Page 26

1 2 1 Acceptable 2 Unacceptable Envelopes with adhesive strips or flaps Envelopes with a peel-off adhesive strip or with more than one flap that folds over to seal must use adhesives that are compatible with the heat and pressure in the printer. The extra flaps and strips might cause wrinkling, creasing, or even jams and might damage the fuser. CAUTION Failure to follow the guidelines above can result in jams. For instructions on loading envelopes, see Loading Tray 1 or Loading Tray 2. Labels Select the type of label that you are using from the Print dialog box or the printer driver. CAUTION To avoid damaging the printer, use only labels that are recommended for laser printers. To prevent serious jams, always use Tray 1 or Tray 2 to print on labels. Never print on the same sheet of labels more than once or print on a partial sheet of labels. When selecting labels, consider the quality of each component: ● Adhesives: The adhesive material should be stable at 210°C (410°F), which is the printer fusing temperature. ● Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets with spaces between the labels, causing serious jams. ● Curl: Before printing, labels must lie flat with no more than 13 mm (0.5 inch) of curl in any direction. ● Condition: Do not use labels that have wrinkles, bubbles, other indications of separation, or are damaged in any way. For instructions on loading labels, see Loading Tray 1 or Loading Tray 2. 14 Chapter 1 Printer basics ENWW