Intel S1200BTL Product Specification - Page 50

Platform Management Intel®Server Board S1200BT TPS 4.2.3 Media Redirection The embedded web server provides a Java applet to enable remote media redirection. This may be used in conjunction with the remote KVM feature, or as a standalone applet. The media redirection feature is intended to allow system administrators or users to mount a remote IDE or USB CD-ROM, floppy drive, or a USB flash disk as a remote device to the server. Once mounted, the remote device appears just like a local device to the server, allowing system administrators or users to install software (including operating systems), copy files, update BIOS, and so on, or boot the server from this device. The following capabilities are supported:  The operation of remotely mounted devices is independent of the local devices on the server. Both remote and local devices are useable in parallel.  Either IDE (CD-ROM, floppy) or USB devices can be mounted as a remote device to the server.  It is possible to boot all supported operating systems from the remotely mounted device and to boot from disk IMAGE (*.IMG) and CD-ROM or DVD-ROM ISO files. See the Tested/supported Operating System List for more information.  Media redirection shall support redirection for a minimum of two virtual devices concurrently with any combination of devices. As an example, a user could redirect two CD or two USB devices.  The media redirection feature supports multiple encryption algorithms, including RC4 and AES. The actual algorithm that is used is negotiated with the client based on the client's capabilities.  A remote media session is maintained even when the server is powered-off (in standby mode). No restart of the remote media session is required during a server reset or power on/off. An Integrated BMC reset (e.g. due to an Integrated BMC reset after Integrated BMC firmware update) will require the session to be re-established  The mounted device is visible to (and useable by) managed system's OS and BIOS in both pre-boot and post-boot states.  The mounted device shows up in the BIOS boot order and it is possible to change the BIOS boot order to boot from this remote device.  It is possible to install an operating system on a bare metal server (no OS present) using the remotely mounted device. This may also require the use of KVM-r to configure the OS during install.  USB storage devices will appear as floppy disks over media redirection. This allows for the installation of device drivers during OS installation.  If either a virtual IDE or virtual floppy device is remotely attached during system boot, both the virtual IDE and virtual floppy are presented as bootable devices. It is not possible to present only a single-mounted device type to the system BIOS. 38 Revision 1.0 Intel order number G13326-003