Kyocera TASKalfa 500ci 500ci/400ci/300ci/250ci Operation Guide Rev-1 - Page 216
Job Finish Notice, Press [Advanced Setup] and then [Job Finish
View all Kyocera TASKalfa 500ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 216 highlights
Sending Functions Job Finish Notice This feature sends an e-mail providing notification that transmission has been completed. Use the procedure below to specify the Job Finish Notice settings. 1 Press the Send key. 2 Place the originals on the platen. 3 Press [Advanced Setup] and then [Job Finish Notice]. Ready to send. Place original. Job Finish Notice Off Address Book Destination Address Entry Detail Destination Detail Address Book 4 To select the destination from the address book, press [Address Book] on the left of the screen and then press [Address Book] in the next screen. Select the destination to be notified, then press [OK]. You can view information on the notification destination by pressing [Detail]. Status Add Shortcut Cancel OK 10/10/2008 10:10 5 Specify the destination to send the finish notice, and press [OK]. Ready to send. Place original. Job Finish Notice Off Address Book E-mail Address Address Entry Destination NOTE: For the procedure to select the destination from the Address Book, refer Specifying Destination on page 3-37. 6 To directly enter the address, press [Address Entry] and then [E-mail Address]. Status Add Shortcut 5-32 Cancel OK 10/10/2008 10:10 7 Enter the E-mail address, and press [OK]. 8 Press [OK]. 9 Specify the destination, and press the Start key to start sending. When the sending is completed, the finish notice is sent to the specified E-mail address. OPERATION GUIDE