Kyocera TASKalfa 500ci 500ci/400ci/300ci/250ci Operation Guide Rev-1 - Page 325

Color Calibration Cycle Auto Item Default Setting (System Menu) 4 Find the location on each chart where 2 lines most closely match. If this is the 0 position, registration for that color is not required. For the illustration, B is the appropriate value. From charts V-1 to V-5, read only the values from V-3 (center). 5 Press [Next] of Registration (Details). 6 Press [Change] for the chart to be corrected. 7 Press [+] or [-] to enter the values read from the chart and press [OK]. Press [+] to increase the value from 0 to 9. To decrease, press [-]. By pressing [-], the value changes from 0 to alphabetic letters, going from A to I. To move in the reverse direction, press [+]. 8 You cannot use the numeric keys to enter these values. 8 Repeat steps 6 and 7 to enter the registration values for each chart. 9 Press [Execute] after all values have been entered. Color registration begins. 10 Press [OK] after color registration is complete. After Auto Clear has been activated, or during printing or while processing Color Registration, Performing Color Calibration... Remaining: 50 seconds may be displayed. While this message is displayed, the machine makes adjustments to maintain image quality. Wait until the message disappears. Set the color calibration cycle here. The setting items are as follows. Description Automatically sets the cycle for color calibration. OPERATION GUIDE 8-61