Kyocera TASKalfa 500ci 500ci/400ci/300ci/250ci Operation Guide Rev-1 - Page 290
E-mail Subject/Body, System Menu, Border Erase Default, Input units, Range
View all Kyocera TASKalfa 500ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 290 highlights
Default Setting (System Menu) E-mail Subject/Body Set the subject and body automatically entered (default subject and body) when sending the scanned originals by E-mail. NOTE: Refer to Send as E-mail on page 3-32. Use the procedure below to set the default e-mail subject and message body. 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ], and then [Change] of E-mail Subject/ Body. 3 Press [Subject] to enter an E-mail subject not more than 60 characters. Border Erase Default NOTE: Refer to the Character Entry Method on Appendix-7 for details on entering characters. 4 Press [OK]. 5 Press [Body] to enter an E-mail Body not more than 500 characters. 6 Press [OK]. 7 Check that the entries are correct and press [OK]. Set the default width to be erased as a border. The table below shows the measurement ranges that can be set. Input units Inch Metric Range 0 to 2" (in 0.01" increments) 0 mm to 50 mm (in 1 mm increments) NOTE: Refer to page 4-27 and page 5-26 for Border Erase. Use the procedure below to set the default border erase width. 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] and then [Change] of Border Erase Default. 3 Press [+] or [-] for the Border and Gutter width to erase. 8-26 OPERATION GUIDE