Kyocera TASKalfa 500ci 500ci/400ci/300ci/250ci Operation Guide Rev-1 - Page 284

Default Setting (System Menu) Function Defaults Defaults are the values automatically set after the warm-up is completed or the Reset key is pressed. Set the defaults for available settings such as copying and sending. Setting the frequently-used values as defaults makes subsequent jobs easier. IMPORTANT: When you have changed the defaults, to enable the change immediately, move to the copy, send, or document box screen and press the Reset key. Original Orientation Set the original orientation defaults. The available default settings are shown below. Item Top Edge Top Top Edge Left Description Select the original's top edge at the top. Select the original's top edge at the left. Refer to page 4-11 for Original Orientation. Use the procedure below to select the default orientation when originals are placed on the platen. 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Original Orientation. 3 Select [Top Edge Top] or [Top Edge Left] for the default. 4 Press [OK]. Continuous Scan Set the continuous scan defaults. The available default settings are shown below. Item Off On Description Continuous scan not performed Continuous scan performed Refer to page 4-11 for Original Orientation. Use the procedure below to select the default settings for continuous scanning. 1 Press the System Menu key. 2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Continuous Scan. 3 Select [Off] or [On] for the default. 8-20 OPERATION GUIDE