Kyocera TASKalfa 500ci 500ci/400ci/300ci/250ci Operation Guide Rev-1 - Page 354
TCP/IP (IPv6) Setup, Default Setting System Menu, OPERATION GUIDE, Network, TCP/IP Setting, TCP/IP
View all Kyocera TASKalfa 500ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 354 highlights
Default Setting (System Menu) TCP/IP (IPv6) Setup Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6): Off. Use the procedure below. 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting. 3 Press [Change] of TCP/IP. 4 Press [On] and then press [OK]. 5 Press [Next] of IPv6. 6 Press [Change] of IPv6. 7 Press [On]. IP Address (Link Local) appears. 8 Press [OK]. 9 After changing the setting, restart the system or turn the machine OFF and then ON again. For detailed information on restarting the system, refer to Restarting the System on page 8-88. Manual Setting (IPv6) Manually specify the IP address, prefix length, and gateway address of TCP/IP (IPv6). The manual setting is available when selecting [On] for TCP/IP (IPv6). Use the procedure below. 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting. 3 Press [Next] of IPv6. 4 Press [Next] of Manual Setting. 5 Press [IP Address (Manual)] to enter IP address. The format of the IPv6 address is a sequence of numbers (128 bit in total) separated by colons, e.g. 2001:db8:3c4d:15::1a2c:1a1f. 6 Press [OK]. Press [# Keys] of Prefix Length (0 - 128) to enter the prefix length using the numeric keys. 7 Press [Default Gateway] to enter the default gateway. 8 Check that all the entries are correct and Press [OK]. 8-90 OPERATION GUIDE