Singer C440 LEGACY Instruction Manual and Troubleshooting Guide - Page 43

Pop-up Messages Raise the Needle If the needle is in lowered position and need to be raised before function can be executed, this pop-up message is shown. Raise the needle and press the "✓" button to close the pop-up message. Machine Set for Twin Needle This pop-up message will appear when ■ Twin Needle program is activated. Check the needle and press the "✓" button to continue. I Raise the Presser Foot This Stitch Cannot Be Sewn with 4 This pop-up will appear when the function has chosen that the presser foot must be up position. Press the "✓" button and raise the presser foot lifter. ■ Twin Needle This message will appear when a stitch that cannot be used with twin needle, is selected.Press the "✓" button and select another pattern or reset the twin needle • 4 program. • Lower the Presser Foot This pop-up will appear when you start the sewing without lowering the presser foot. Press the "✓" button and lower the presser foot lifter to start to sew. Stitch Width Limited for Twin ■ Needle This message will appear when stitch width is adjusted to the limit. Press the "✓" button to continue. • 4 14-H 4 Calibration Failed If calibration has not completed correctly, pop-up message will appear. Press the "✓" button and retry the calibration. • • • 11 . . . Lower the Feed Teeth Lever When sewing on a button, this pop-up will appear. Lower the feed teeth lever and press the "✓" button to continue. . V • A • Thread Jam If upper or bobbin thread is jammed under the needle plate, machine will stop and pop-up this message. Remove the needle plate (see page 45) Remove the thread jam and reset needle plate. Press the "✓" button. i Main Motor Overload If you are sewing on very heavy fabric or if the machine is blocked when sewing, the main motor can get overloaded and the machine will stop sewing. The pop-up message will close when the main motor and power supply are secure. 6 This Stitch Cannot be Combined Some patterns may not be combined into the sequence. If you select a pattern that cannot be combined, a message will appear on screen to alert you of this. Press the "✓" button. • 4 I 0 Program Too Long to Add More Stitches The sequence can contain a maximum of 40 patterns and letters. Message will appear when you come to the limit. Press the "✓" button. a. POP-UP MESSAGES Delete Program When deleting all patterns, a pop up will appear, press the "✓" button. Machine will delete all selected patterns and letters. To ro cancel, press the "X" button. Overwrite If the selected folder already has a memorized sequence in it, a message will appear asking to overwrite the previous sequence or not. To overwrite (deleting previous sequence), press the "✓". To 4 cancel (exit), press the "X". The message will disappear. 4 00 X X