Brother International MFC-7050C Service Manual - Page 111
Communications, setting, Selector, Starting, point, training, check, WSW26, Function, setting,
View all Brother International MFC-7050C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Selector No. 1 2 I 8 WSW23 (Communications setting) Function Starting point of training check (TCF) Setting and Specifications 0: From the head of a series of zeros 1: From any arbitrary point Not used. • Selector 1: Starting point of training check (TCF) At the training phase of receiving operation, the called station detects for 1.0 second a training check (TCF) command, a series of zeros which is sent from the calling station for 1.5 seconds to verify training and give the first indication of the acceptability of the line. This selector sets the starting point from which the called station should start counting those zeros. If this selector is set to "0," the called station starts counting zeros 100 ms after the head of a series of zeros is detected. If it is set to "1," the called station starts counting zeros upon detection of 10-ms successive zeros 50 ms after the head of a series of zeros is detected. In this case, if the detection of 10-ms successive zeros is too late, the data counting period will become less than 1.0 second, making the called station judge the line condition unacceptable. WSW26 (Function setting 1) Selector No. 1 5 6 7 8 Function Not used. No. of CNG cycles to be detected (when the line is connected via the external telephone in the external TAD mode or via the facsimile equipment in F/T mode) Not used. Setting and Specifications No. 6 7 0 0 : 0.5 (A) 01 : 1 (B) 1 0 : 1.5 (C) 11 : 2 (D) NOTE: Selectors 6 and 7 are applicable to those models equipped with a built-in TAD. • Selectors 6 and 7: No. of CNG cycles to be detected The equipment interprets a CNG as an effective signal if it detects a CNG signal by the number of cycles specified by these selectors when the line is connected via the external telephone in the external TAD mode or via the facsimile equipment in F/T mode. V - 15