Brother International MFC-7050C Service Manual - Page 43
screwdriver
View all Brother International MFC-7050C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
(12) As shown below, insert the tip of a flat screwdriver under clamp "A" from the rear and push up clamp "A" slightly to release the LCD, and then take out the LCD while pulling the LCD flat cable gently. NOTE: Do not take out the LCD except when the LCD is defective and requires replacement. LCD flat cable Clamp LCD Control panel (Rear) Clamp "A" Flat screwdriver ■ Reassembling Notes • Before reinstalling the LCD to the control panel, wipe fingerprints or dust off the LCD surface and control panel window with a soft cloth. • A new LCD is covered with a protection sheet. Before installing it, remove the protection sheet. • To put the LCD back into place, insert the tip of a flat screwdriver under clamp "A" from the rear, push up clamp "A" slightly, and then push the LCD to the rear with your thumbs. IV - 11