Brother International MFC-7050C Service Manual - Page 118
Error, Indication
View all Brother International MFC-7050C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
1. ERROR INDICATION To help the user or the service personnel promptly locate the cause of a problem (if any), the facsimile equipment incorporates the self-diagnostic functions which display error messages for equipment errors. If an equipment error occurs, the facsimile equipment emits an audible alarm (continuous beeping) for approximately 4 seconds and shows the error message on the LCD. For the error messages, see below. Error messages on the LCD Messages on the LCD CHECK PAPER PRINTER JAM COVER OPEN DOCUMENT JAM Probable Cause The registration sensor detects no recording paper loaded in the ASF. The registration sensor detects that a paper jam has occurred. The cover sensor detects that the top cover is not closed. ■ Document jam (1) The document length exceeds the limitation (90 cm). (Both the document front and rear sensors stay ON even after the document has been fed by the registered length.) (2) The document rear sensor detects no trailing edge of a document after the document has been fed by 400 cm. (The document rear sensor stays ON even after the document has been fed when the document front and rear sensors were OFF and ON, respectively.) ■ Document loading error (1) The document rear sensor detects no leading edge of a document within 10 seconds from the start of document loading operation. (The document rear sensor stays OFF even after the document has been fed when the document front sensor was ON.) (2) The loaded document is too short. (Since the document is shorter than the distance between the document front and rear sensors, the document front sensor is turned OFF before the document rear sensor is turned ON.) VI- 1