Brother International MFC-7050C Service Manual - Page 86
Bearing
View all Brother International MFC-7050C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
1.31 Large Feed Roller ASSY (1) At each of the right and left ends of the large feed roller shaft, pull the arm of the bearing outwards, turn it clockwise (when viewed from the left), and pull it out. NOTE: These bearings may be glued to the frame chassis and gear plate, so you need to remove the glue. (2) Push the large feed roller ASSY to the right and take it up and out of the frame chassis. Frame chassis 0 O 0 Bearing Edge "x" Bearing Large feed rollerASSY Damper bearing • Reassembling Notes • When setting the bearings to the frame chassis back into place or replacing them with new ones, no gluing is required. • After setting the large feed roller ASSY to the frame chassis, make sure that the bottom end of the damper bearing is fitted on edge "x" of the frame chassis. IV - 54