Dell PowerConnect 3524 User's Guide - Page 133
Apply Changes, Interface Parameters, Show All., Remove - vlan configuration
View all Dell PowerConnect 3524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
3 Modify the interface type. 4 Click Apply Changes. The parameters are modified, and the device is updated. Deleting IPv4 Addresses 1 Open the IPv4 Interface Parameters page. 2 Click Show All. The Interface Parameters Table page opens. Figure 6-29. IPv4 Interface Parameter Table 3 Select an IP address and select the Remove check box. 4 Click Apply Changes. The selected IP address is deleted, and the device is updated. Defining IPv4 Interfaces Using CLI Commands The following table summarizes the equivalent CLI commands for setting fields displayed in the IPv4 Interfaces Parameters page. Table 6-20. IPv4 Interface Parameters CLI Commands CLI Command Description ip address ip-address {mask | Sets an IP address. prefix-length} no ip address [ip-address] Removes an IP address show ip interface [ethernet Displays the usability status of interfaces interface-number | vlan vlan- configured for IP. id | port-channel number] Configuring System Information 133