Dell PowerConnect 3524 User's Guide - Page 149

• Type - Displays the type of the neighbor discovery cache information entry. The possible field values are: - Static - Shows static neighbor discovery cache entries. If an entry for the specified IPv6 address already exists in the neighbor discovery cache-as learned through the IPv6 neighbor discovery process-you can convert the entry to a static entry. - Dynamic - Shows dynamic neighbor discovery cache entries. • Remove - When selected, removes the neighbor from the list. In the IPv6 Neighbors Table, the following additional parameter appears: • State - Displays the IPv6 Neighbor status. The field possible values are: • Incomplete - Indicates that an address resolution is in progress and the link-layer address of the neighbor has not yet been determined. • Reachable - Indicates that the neighbor is known to have been reachable recently (within tens of seconds ago). • Stale - Indicates that the neighbor is no longer known to be reachable but until traffic is sent to the neighbor, no attempt is made to verify its reachability. - Delay - Indicates that the neighbor is no longer known to be reachable, and traffic has recently been sent to the neighbor. Rather than probe the neighbor immediately, however, there is a delay sending probes for a short while in order to give upper-layer protocols a chance to provide reachability confirmation. - Probe - Indicates that the neighbor is no longer known to be reachable, and unicast Neighbor Solicitation probes are being sent to verify reachability. Adding an IPv6 Neighbor 1 Open the IPv6 Neighbors page. 2 Click Add. The Add IPv6 Neighbors page opens. Figure 6-40. Add IPv6 Neighbors Configuring System Information 149