Dell PowerConnect 3524 User's Guide - Page 389

Enabling IGMP Snooping on the device 1 Open the Global Parameters page. 2 Select Enable in the IGMP Snooping Status field. 3 Click Apply Changes. IGMP Snooping is enabled on the device. Enabling Multicast Filtering and IGMP Snooping Using CLI Commands The following table summarizes the equivalent CLI commands for enabling Multicast Filtering and IGMP Snooping as displayed on the Global Parameters page. Table 7-38. Multicast Filtering and Snooping CLI Commands CLI Command bridge multicast filtering ip igmp snooping Description Enables filtering of Multicast addresses. Enables Internet Group Membership Protocol (IGMP) snooping. The following is an example of the CLI commands: console(config)# bridge multicast filtering console(config)# ip igmp snooping Adding Bridge Multicast Address Members The Bridge Multicast Group page displays the ports and LAGs attached to the Multicast service group in the Ports and LAGs tables. The Port and LAG tables also reflect the manner in which the port or LAGs joined the Multicast group. Ports can be added either to existing groups or to new Multicast service groups. The Bridge Multicast Group page permits new Multicast service groups to be created. The Bridge Multicast Group page also assigns ports to a specific Multicast service address group. To open the Bridge Multicast Group page, click Switch → Multicast Support → Bridge Multicast Group in the tree view. Configuring Switch Information 389