Dell PowerConnect 3524 User's Guide - Page 360
The LAG VLAN mode. Possible values are, Current Reserve VLAN
View all Dell PowerConnect 3524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 360 highlights
The VLAN LAG Settings page contains the following fields: • LAG - The LAG number included in the VLAN. • LAG VLAN Mode - The LAG VLAN mode. Possible values are: - Customer - The LAG belongs to VLANs. When LAGs are in Customer mode, the added tag provides a VLAN ID to each customer, ensuring private and segregated network traffic. - General - The LAG belongs to VLANs, and each VLAN is user-defined as tagged or untagged (full 802.1Q mode). - Access - The LAG belongs to a single, untagged VLAN. - Trunk - The LAG belongs to VLANs in which all ports are tagged (except for one port that can be untagged). • Dynamic - Assigns a LAG to a VLAN based on the host source MAC address connected to the LAG. The possible values are: - Checked - The LAG may be registered in a dynamic VLAN. - Unchecked - The LAG is not allowed to register in a dynamic VLAN. • PVID (1-4095) - Assigns a VLAN ID to untagged packets. The possible field values are 1-4095. VLAN 4095 is defined as per standard and industry practice, as the Discard VLAN. Packets classified to this VLAN are dropped. • Frame Type - Packet type accepted by the LAG. The possible values are: - Admit Tag Only - Only tagged packets are accepted by the LAG. - Admit All - Tagged and untagged packets are both accepted by the LAG. • Ingress Filtering - Enables or disables Ingress filtering by the LAG. Ingress filtering discards packets that are destined to VLANs of which the specific LAG is not a member. The possible values are: - Enable - Ingress filtering is activated on the LAG. - Disable - Ingress filtering is not activated on the LAG. • Current Reserve VLAN - The VLAN currently designated as the reserved VLAN. • Reserve VLAN for Internal Use - The VLAN that is designated as the reserved VLAN after the device is reset. Assigning VLAN LAG Settings: 1 Open the VLAN LAG Settings page. 2 Select a LAG from the LAG drop-down menu and complete the fields on the page. 3 Click Apply Changes. The VLAN LAG parameters are defined, and the device is updated. 360 Configuring Switch Information