Dell PowerConnect 3524 User's Guide - Page 136
interface ethernet, ip address dhcp, DHCP IPv4 Interface, Show All, Remove, Apply Changes
View all Dell PowerConnect 3524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Deleting a DHCP IPv4 Interface 1 Open the DHCP IPv4 Interface page. 2 Click Show All. The DHCP IPv4 Interface Table opens. Figure 6-32. DHCP IPv4 Interface Table 3 Select a DHCP client entry. 4 Select the Remove check box. 5 Click Apply Changes. The selected entry is deleted, and the device is updated. Defining DHCP IPv4 Interfaces Using CLI Commands The following table summarizes the equivalent CLI commands for defining DHCP clients. Table 6-21. DHCP IPv4 Interface CLI Commands CLI Command Description ip address dhcp To acquire an IP address on an Ethernet interface from the [hostname host-name] Dynamic Host Configuration Protocol (DHCP). The following is an example of the CLI command: console(config)# interface ethernet 1/e11 console(config-if)# ip address dhcp 136 Configuring System Information