Dell PowerConnect 3524 User's Guide - Page 139
Add a Static IPv4 Interface, IPv6 Address Origin Type
View all Dell PowerConnect 3524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
• IPv6 Address Origin Type - Defines the type of configurable static IPv6 address for an interface. The possible values are: - Dyanmic - Indicates the IP address was received from RA. - Static - Indicates the IP address was configured by the user. - System - Indicates the IP address was generated by the system. • DAD Status - Displays the Duplicate Address Detection (DAD) Status which is the process of verifying and assuring an inserted IPv6 address is unique. This is a read-only parameter with the following field values: - Tentative - Indicates the system is in process of IPv6 address duplication verification. - Duplicate - Indicates the IPv6 address is being used by an another host on the network. The duplicated IPv6 address is suspended and is not used for sending or receiving any traffic. - Active - Indicates the IPv6 address is set to active. • Remove - When selected, removes the address from the table. Adding an IPv6 Interface 1 Open the IPv6 Interface page. 2 Click Add IPv6 Interface. The Add a Static IPv4 Interface page opens. Figure 6-34. Add IPv6 Interface 3 Complete the fields on the page. IPv6 Interface specifies whether the interface is a specific port, LAG or VLAN. 4 Click Apply Changes. The new interface is added, and the device is updated. Configuring System Information 139