Dell PowerConnect 3524 User's Guide - Page 321
Configuring GARP, Defining GARP Timers
View all Dell PowerConnect 3524 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
The following is an example of the CLI commands: console (config)# bridge aging-time 250 console (config)# end console# show bridge address-table Aging time is 250 sec vlan ---1 1 200 mac address ----------00:60:70:4C:73:FF 00:60:70:8C:73:FF 00:10:0D:48:37:FF port ---1/e8 1/e8 1/e8 type ---dynamic dynamic static Configuring GARP Generic Attribute Registration Protocol (GARP) is a general-purpose protocol that registers any network connectivity or membership-style information. GARP defines a set of devices interested in a given network attribute, such as VLAN or multicast address. When configuring GARP, ensure the following: • The leave time must be greater than or equal to three times the join time. • The leave-all time must be greater than the leave time. • Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on the Layer 2-connected devices, GARP application does not operate successfully. To open the GARP page, click Switch → GARP in the tree view. This section contians the following topics: • "Defining GARP Timers" on page 322 Configuring Switch Information 321