Dell PowerConnect 3524 User's Guide - Page 276

Configuring Locked Port Security with CLI Commands The following table summarizes the equivalent CLI commands for configuring Locked Port security as displayed in the Port Security page. Table 7-4. Port Security CLI Commands CLI Command Description shutdown Disables interfaces. set interface active {ethernet interface | port- Reactivates an interface that is shutdown due to channel port-channel-number} port security reasons. port security learning {disabled | dynamic} Defines the locked port type. port security max max-addr Specifies the number of MAC address that can be learned on the port. port security [forward | discard | discardshutdown] [trap seconds] Locks learning of new addresses on an interface. show ports security {ethernet interface | port- Displays port lock status. channel port-channel-number} The following is an example of the CLI commands: console # show ports security Port ----1/e1 1/e2 Status ------locked locked 1/e3 Unlocked Action ------Discard Discard, Shutdown - Trap ------Enable Disable - Frequency --------100 Counter -------88 - - ACL Overview Access Control Lists (ACL) allow network managers to define classification actions and rules for specific ingress ports. Packets entering an ingress port, with an active ACL, are either admitted or denied entry and the ingress port is disabled. If they are denied entry, the user can disable the port. This section contians the following topics: • "Defining IP based ACLs" on page 277 • "Defining MAC Based Access Control Lists" on page 283 • "Defining ACL Binding" on page 286 276 Configuring Switch Information