Epson FX-2180 User Manual - Page 4

Control Panel Buttons and Lights Font button Selects the font. See Chapter 5. Font lights Indicate which font is selected. Pitch button Selects the font size. See Chapter 5. Pitch lights Indicate what font size is selected. Pause button Stops printing temporarily, and resumes printing when pressed again. Pause light • On when the printer is paused. • Flashes when the printer is in the micro adjust mode. Paper Out light • On when no paper is loaded in the selected paper source or paper is not loaded correctly. • Flashes when paper has not been fully ejected or a paper jam has occurred. Tear Off/Bin button • Advances continuous paper to the LF/FF button • Feeds paper line by tear-off position. • Feeds continuous paper backward from line. • Ejects a single sheet the tear-off position to the top-of-form or advances position. • Selects a cut-sheet feeder bin when the continuous paper to the next cut-sheet feeder is installed. • Enters the card mode to print on top-of-form position when held down. postcards and envelopes. See Chapter 3. Operate button Turns the printer on and off. The printer is off when the top of this button is even with the button protectors. Load/Eject button • Loads a single sheet of Tear Off/Bin lights • f f when continuous paper is in the tear-off position. • o n when bin 1 of the optional cut-sheet feeder is selected. • n o when bin 2 of the optional cut-sheet feeder is selected. • n n when the printer is in the card mode. paper. • Ejects a single sheet of paper if a sheet is loaded. • Loads continuous paper from the standby position. • Feeds continuous paper backward to the n = On f = Flashing o = Off standby position. Micro Adjust When holding down the Pause button for three seconds, the printer enters the micro adjust mode. Using the micro adjust feature, you can press the D and U buttons to adjust the top-of-form or tear-off position. See Chapter 2.