HP 4300 Service Manual - Page 283

Table 41. Alphabetical printer messages (continued) Message Description Action LOAD TRAY XX: For help press Tray XX is either empty (based on 1. Press the HELP ( ) button the operation of the paper sensor) for detailed information. or configured for a type and size 2. Press the UP ARROW ( ) other than that specified in the button and the job. No other tray is available. DOWN ARROW ( ) button to step through the instructions. 3. Print a configuration page and verify that the tray settings are correctly set. See "Configuration page" on page 241. 4. If the tray settings on the configuration page do not match the actual tray setting, verify that the indicated tray's paper width switch (PS106, SW801, or SW1) is operating correctly. See figure 213 on page 336, figure 217 on page 340, or figure 220 on page 343. LOWER THE OPTIONAL BIN Note: The stacker or stapler/stacker LED blinks in amber. The stacker or stapler/stacker 1. output bin is in the raised position. 2. Lower the output bin. If this error persists, replace the stacker or stapler/stacker. MANUALLY FEED For help press alternates with MANUALLY FEED To continue press A job was sent that requires a specific paper type and size that is not currently available. 1. Press the HELP ( ) button for detailed information. 2. Press the UP ARROW ( ) button and the DOWN ARROW ( ) button to step through the instructions. 3. If the requested paper size and type is installed in one of the trays, print a configuration page (see "Configuration page" on page 241) to see if the printer tray setting differ from the paper size and type in the tray. 4. Check the tray size sensor switches if the configuration page indicates a different size than that in the tray. Verify that the sensor "fingers" inside the tray are engaging the tray sensor correctly. See "Tray 2, 500-, 1,500-sheet feeder media size detection" on page 83. Q2431-90912 Chapter 7 Troubleshooting 263